RF Network Analizer HP 8712C 300kHz-1300MHz

Art.1976

New product

RF Network Analizer HP  8712C  300kHz-1300MHz

More details

call / mail for more info

Data sheet

Brand / Type HP 8712C 300kHz-1300MHz
Extra info Including RF probe type 85024A (300kHz-3GHz)

More info

Receiver 

8712C 

Frequency range:

Narrowband: 300 kHz to 1.3 GHz 300 kHz to 3.0 GHz

Broadband: 0.01 to 1.3 GHz 0.01 to 3.0 GHz 

Dynamic range 2

Narrowband:

50 ohm >100 dB, ? 5 MHz >100 dB

(+10 to –90 dBm) (+10 to –90 dBm) 

>60 dB, <5 MHz

(+10 to –50 dBm)

75 ohm >97 dB, >5 MHz >97 dB 

(+10 to –87 dBm) (+10 to –87 dBm) 

>57 dB, <5 MHz 

(+10 to –47 dBm) 

Broadband:

50 ohm > 66 dB >66 dB 

(+16 to –50 dBm) (+16 to –50 dBm)

75 ohm > 63 dB >63 dB 

(+16 to –47 dBm) (+16 to –47 dBm)

Maximum input:

Narrowband: +10 dBm +10 dBm 

(0.5 dB compression) 

Broadband: +16 dBm +16 dBm

(0.55 dB compression)

Damage level +23 dBm, +23 dBm,

±25 VDC ±25 VDC 

Trace noise 3

Medium BW ±0.2 dB ±0.2 dB

Narrow BW ±0.1 dB ±0.05 dB

 

2. Receiver dynamic range is calculated as the difference between maximum 

receiver input level and receiver’s noise floor. 

System dynamic range applies to transmission measurements only, since 

reflection measurements are limited by directivity.

Noise floor is specified as the mean trace noise at specified CW frequencies. 

A signal at this level would have a signal to noise ratio of 3 dB. Noise floor is

measured with test ports terminated in loads, response and isolation calibration,

15 Hz IF bandwidth, 10 dB source power, and no averaging.

 

3. Measured at 0 dBm, excluding frequency response, transmission measurement.

10 5 0 —5 —10—15—20—25—30—35—40—45—50—55—60—65

—70—75—80—85—90—95—100

3 / 2.5 / 2 / 1.5 / 1 / 0.5 / 0

Reference Power Level: —20 dBm 

Input Power Level: (dBm) 

Error (dBm) 

+16 10 0 –10 –20 –30 –40 –50